The 3D PuffPro

This tool features 2 different ends for all the necessary cleaning functions of your 3D foam. The first end is a pointed tip that will help you poke in those small areas of foam that are sticking out of your embroidery. 

 With corners and fine bits that tend to remain after tearing away excess foam - this end in fine enough to poke in these small areas, but is also dulled enough not to damage your stitches, garment or foam.  The pointed end also helps to dig out  the smaller areas of excess foam that needs to be removed from your design. The second end features a flat service with a rounded corner and a squared corner.  

The edges of this end are also dulled  enough, so you don't damage your garment or thread.   The flat end works like a safe cutting blade that you can run along your embroidery, to help "cut" the excess foam away from your design.   Using this function, instead of just tearing away the excess foam, helps eliminate the small areas that of foam that pulled away and stick out from the sides of your embroidery.  

This flat end also is used on areas of foam that are sticking out from the top surface of your stitches - this edge is gentle enough to push longer piece of foam back under the top stitches. The flat end's edge is also a perfect way to slide between your stitches and and excess foam, and lift up the edge of the foam in order to pull it away.  Using the 3D PuffPro along with the proper heat application - your 3D puff designs will have the professional, flawless look you strive for.  

Stop using the tips of your scissors or other sharp objects that can damage you garment and thread - use the 3D PuffPro for all your puff embroidery clean up needs!

Made in USA